Instruction Manual

5
|
www.bs-battery.com
ACCESSORIES INCLUDED
1x Tester case.
1x USB cable to connect the tester to the computer (for printing).
1x User Manual.
COLD CRANKING AMPS MEASURE RANGE
Lithium Ion Battery
Regular Flooded,
AGM Gel battery, EFB
Measure
Standard
Measure Range
Measure
Standard
Measure Range
CCA 20-1000 CCA 20-2000
BCI 100-2000 BCI 100-2000
CA 20-1000 CA 20-2000
MCA 20-1000 MCA 20-2000
JIS 26A17—150F51 JIS 26A17--245H52
DIN 20-700 DIN 20 -1400
IEC 20-700 IEC 20 -1400
EN 20-1000 EN 20-2000
SAE 20-1000 SAE 20-2000
GB 2-120 GB 2-220
OPERATION AND TEST
Ensure that the area is well ventilated before performing a test.
Make sure that the battery connections are clean. If necessary, clean them using a wire
brush. Any presence of oxidation between the tester terminals and the battery connectors
or between the battery connectors and the battery terminals reduces the effectiveness
of the tester.
If the battery is out of the vehicle:
Connect the negative plug (black) to the negative terminal of the battery.
Connect the positive plug (red) to the positive terminal of the battery.
If the battery is in the vehicle:
As there may be some electricity between the generator and the battery, called floating
electricity, if the battery tester is connected directly to the battery, only the floating power
will be tested, not the power inside the battery, so the result is inaccurate.
Therefore, before connecting the tester to the battery, it is better to ignite rst, turn on
the headlights to remove the floating electricity. After that make sure that the ignition
and the consumers are switched off.
Connect the negative plug (black) to the negative terminal of the battery.
Connect the positive plug (red) to the positive terminal of the battery.