User's Manual

38
Cardio 40/60 User’s Manual
Installing the Heart Rate Monitor
C
L
O
S
E
O
P
E
N
2
C
L
O
S
E
O
P
E
N
1
4
3
5
Sensors
Heart Rate
NOTE:
Adjust the sensor position to the middle part of the body. The belt should be worn •
under the chest and directly on your body. The Bryton logo shown on the sensor should
be facing upward. Tighten the elastic belt rmly so that it will not turn loose during the
exercise.
In cold weather, wear appropriate clothing to keep the heart rate belt warm.•
If the sensor cannot be detected or the reading is abnormal, please wet the electrodes area •
with water as shown in the step 3 or warm up the heart rate sensor for about 5 minutes.
If the heart rate belt is not used for a period of time, remove the sensor from the heart rate •
belt to prevent the battery from running at.
Heart rate sensor does not work under water. This is common to all ANT+ sensors.•
For triathlon, it is recommended to wear Heart rate belt after swimming as water will •
reduce the strength of heart beat signal. If the heart rate belt is wore before swimming,
heart rate data may not be properly recorded after leaving the water for a period of time.