BRYSTON SST PERFORMANCE DRIVEN
10 B ELECTRONIC CROSSOVER Bryston’s Model 10B Electronic Crossover combines ideal frequencies more suitable to sub-woofer applications and a signal-handling with an enormously flexible control function. 10B standard which is more applicable to speakers reacquiring Simple, direct front-panel switches allow any crossover curve frequency control in the midband and tweeter areas. to be set instantly, and the signal purity is always maintained.
10B SWITCHING AND CONNECTIONS (B) (C) (D) (E) (F) (A) (I) (G) (J) (K) (H) (L) (K) (A) (B) (C) (J) (D) (I) (A) MUTE SWITCH (F) HIGH PASS FREQUENCY SELECTOR (B) LOW PASS FREQUENCY SELECTOR (G) STATUS LEDS One each for low pass and high pass filters 12 selectable crossover points (C) LOW PASS SLOPE SELECTOR Sets low pass slope in decibels per octave (6, 12 or 18dB/Oct.) (D) HIGH PASS LEVEL CONTROL Sets high pass output level for channel. -5dB to + 5dB in 1dB steps.
POWERPAC SST MONAURAL AMPLIFIERS The Bryston PowerPac Amplifiers are a modular monaural version of our very popular stereo amplifiers but designed to be utilized in applications where portability, sound quality and flexibility are of prime importance. VERSATILE FEATURES The PowerPac Amplifiers are a perfect choice for use as a portable power amplifier which can be attached directly to the rear of your loudspeaker.
POWER PAC COMPARISON CHART MODEL WATTS DISTORTION NOISE INPUT SENSITIVITY AND IMPEDANCE DIMENSIONS POWERPAC 60 watts @ 8 ohms 100 watts @ 4 ohms < 0.009% from 20Hz to 20kHz @ 60 watts IM or THD > 101dB below full output .75V in for 60 watts out @ 8 ohms 50k unbalanced, 20k balanced 12 x 1.8 x 7.1 inches 30.5 x 4.7 x 17.9 cm wt: 5 lbs, 2.6 kg POWERPAC 120 watts @ 8 ohms 200 watts @ 4 ohms < 0.008% from 20Hz to 20kHz @ 1200 watts IM or THD > 104dB below full output 1.
BRYSTON INTERCONNECT CABLES BRYSTON ANALOG/ DIGITAL/VIDEO CABLE We at Bryston, do not think cables should be ‘voiced’ to sound a specific way. The best cable is NO cable at all so we contend that the best cable is the cable that changes the signal the least. DIGITAL CABLES The geometry (where the plus is relative to the minus) of a cable determines the inter-relationship between the measured performance of a specific cable. These measured performance criteria are call the ‘Primary Constants’.
BRYSTON SPEAKER CABLES SPEAKER CABLES RECOMMENDATIONS: The Amplifier/Speaker interface is a ‘low impedance’ connection. Therefore, in a speaker cable you are looking for low ‘self inductance’ (because inductance rolls off the top end) as opposed to ‘low capacitance’ required in the RCA or XLR analogue interconnect. For speaker cables we use a stranded 9 gauge linear crystal copper with ‘Heavily Gold plated’ Spade lugs or Expandable Banana plugs specially made for Bryston.
BRYSTON WARRANTY In a world where most things seem to need frequent that could result in long-term reliability problems. a comprehensive, unconditional, and fully transferable some last-minute go/no-go check; at every stage individual upgrading, repair, or replacement, how can Bryston offer warranty on every audio product we make? The answer would quickly become apparent if you were to tour Bryston’s plant in Peterborough, Ontario, Canada.
