User Manual

1. INSERT: Gently insert your
MacBook into the bottom
of the black sleeve.
HAVE A QUESTION? Visit www.brydge.com/support
ASSEMBLY
INSERT & REMOVE
NOTE: To use external displays with the MacBook in the Vertical Dock, power must be connected, along with an
external keyboard/mouse.
Dropping the MacBook into the Vertical Dock can damage the ports and dock connectors. Forcing or wobbling the
computer into or out of the dock could result in port damage. Make sure that your grip on the computer is secure
before docking and undocking.
Do not insert upside down or backwards, this may result in port damage or cosmetic damage to your MacBook. The
MacBook should only be docked with the left-side ports down and the monitor hinge to the rear of the dock.
Cosmetic wear to the surface finish may result from any device that plugs into the MacBook, including the Vertical
Dock. Minor wear around the MacBook’s ports is considered normal.
PROPER USAGE
2. Turn the chassis upside down.1. Remove base, chassis, screws &
screwdriver from packaging.
3. Place base so that it fits snugly to
chassis & screw holes are aligned.
(Base plate only fits correctly
in one orientation)
5. Flip dock over with Thunderbolt
ports facing toward the back.
4. Tighten the two screws. 6. Connect devices to the
Thunderbolt 3 ports on the
back of the Vertical Dock as you
would with your MacBook ports.
2. SEAT: Push down until the
Thunderbolt ports engage.
3. REMOVE: Pull up and
remove your MacBook.