Specifications

Basics

Setting up a print job means adjusting the printer to ac-

commodate the width, height, thickness and weight of your

material.

There are two things that determine how reliably your

printer feeds: the setup adjustments and the quality of your

material. A good setup minimizes misfeeds and jams. And

your printer will perform at its best when you run material

that falls within our published specifications. See Appendix

B for complete material specifications.

1. Set the Separator Gap

Whenever you switch from one material type to another,

you need to set the gap between the separators and the

feed roller before printing begins.

There are three positions of the "H" Block:

• Lever fully down - adjusted to media thickness (ready to

operate).

• Lever midpoint - not adjusted to any media (free-floating

on media, not set up to operate).

• Lever fully up - locked in the up position, not adjusted to

any media thickness.

Setting Up A

Job