Specifications

Printer Menu System
Menu Items Selections Explanation
CR=CR;LF=LF
CR=CR+LF;LF=LF
CR=CR;LF=CR+LF
CR=CR+LF;LF=CR+
LF
The typical software line termination is CR = CR;
LF = LF. If your software is not typical then the
Line Termination can be modified.
5. HEX DUMP MODE
Utilize this option to print the raw ASCII data (HEX Code) that is being sent to the printer.
Menu Items Selections Explanation
Off or On
Prints the ASCII data being sent to the printer.
The media width must be a minimum of 7 1/2”
or 191 mm when running in HEX Mode. The
page orientation, margins and number of lines
are defined by the ADDRESS LAYOUT and
LINES/ADDRESS. The maximum number of
usable lines is 16.
Note: Clear the data buffer before sending data to
the printer.
6. LANGUAGE
Customize the printer to match the keyboard of your printer, convert measurements from inches
to millimeters and translate the menus from English. Most menus that use inches for
measurements are converted to millimeters.
Menu Items Selections Explanation
A. Symbol Set ISO 6 ANSI
ASCII
ISO 69 FRENCH
ISO 21 GERMAN
ISO 4 UK
ISO 60 NORW /
DAN
ISO 11 SWED /
FIN
ISO 15 ITALIAN
ISO 17 SPANISH
ISO 61 NORW /
Match the printers’ International Standards
Organization (ISO) symbol sets and substitution
tables to the one used by the software.
The printer has International Standard Organization
(ISO) language symbol sets to use when printing in
another language. A symbol set contains collections
of the symbols and characters that make up a
language. For a listing of the characters for the ISO
symbol sets see Appendix D.
Note: The character set CP1250 is only available
after the polish characters are installed on the
machine.
A.
(
Continued
)
Revision C 30K USERS MANUAL Section 6 - 12
P/N 90-00203-001