Specifications

Setting up the Printer

Make certain all the necessary components of the printer are

installed:

Preparing

the Media

• Is the printer plugged into a power outlet?

• Does the printer have at least three black print

cartridges installed in one of the Banks?

• Is the printer connected to the computer?

Now that the printer is installed the setup or adjustments to the

printer need to be done for it to work with the media. To avoid

problems of misfeeding and jams the media must also be made

ready for the printer.

Use the following steps to make the media ready for printing:

1. Take a manageable pile of media and while holding

them (as shown below in reference A), "fan" all sides

of the media to make sure that each piece of media is

free from one another.

Note: Maximum

thickness is 0.5”(1.27

cm).

2. Square the pile against the tabletop, assuring a square

pile on all sides. (Reference B) This will also allow

media to settle toward the bottom of a stuffed envelope

and will increase consistency in the print and increase

the feeding capabilities of the feeder.

Fan All Sides of Media Square Media

Revision C 30K USERS MANUAL Section 3 -

P/N 90-00203-001