User guide

27
3-1-3. Device / G-sensor
 Depending on the installation location and slant, set the “(X), (Y), (Z)” axis
angles using the information provided in REF2 below.
 The “X, Y, Z” axis angles can be set at “0/90/180/270”.
 Set the “Acceleration(FX), Deceleration(RX), Turn(Y), Vertical(Z)” trigger
levels from “0.1G ~ 1.0G”.
 The trigger levels are used as event points when driving data is recorded and
are utilized when searching for excessive G-sensor changes while accelerating,
decelerating, turning, or when in accidents.
Caution!
1. When using an HDD, postion the device in an upright positon only
2. The postions and adjustments in REF2 are ONLY for when using SSDs.