User guide

22
Video Loss, No Camera
Detect Alarm in 4
Motion Detection
Detect Alarm in 5
Audio Record
Detect Alarm in 6
Continuous Record (RED)
Detect Alarm in 7
Event Record (YELLOW)
Detect Alarm in 8
Detect Alarm in 1
Activate Alarm out 1
Detect Alarm in 2
Activate Alarm out 2
Detect Alarm in 3
Detect G-sensor variability
2. Information Screen
1) Press [STA] four times to switch to the Information Screen.
① System Version: Displays firmware version
② Micom (chipset) Version
③ Video Standard: Displays video Standard, either NTSC or PAL
④ Mac Address
⑤ GPS: Displays longitude, latitude, and speed
* If there is no GPS value, check your location to see if there is any GPS
signal reception.
⑥ Alarm In/Out: Displays digital input 1 ~ 7 and digital output 1 ~ 2. 0
means no signal, 1 means there is a signal
⑦ Speed Pulse: Displays speed pulse and speed measured by the vehicle’s
speed pulse
* If the speed indicated here varies with the vehicle’s speedometer, please
re-configure the car pulse type by going to [Menu -> Device -> Signal ->
Carpulse Type] and selecting the correct type.
⑧ Car Signal: Displays car signals