Use and Care Manual

– 11 –
ALWAYS WEAR PROPER SAFETY EQUIPMENT at all
times when operating the saw. Wear goggles and
dust mask at all times when operating saw.
ALWAYS ENSURE A CONTINUOUS FLOW OF WATER on
both sides of the blade before cutting any material.

GUARDS IN POSITION.

OR SMALLER THAN RECOMMENDED.

DO NOT EXCEED MAXIMUM RPMS recommended by
the blade manufacturer.
 DO NOT FORCE THE MATERIAL into the blade. Let the
blade cut at its own speed.

BLADE MANUFACTURER.
TROUBLESHOOTING
IF THE SAW IS OVERHEATING:

touch.

blockage and dirt.
IF THE SAW DOES NOT START:



outlet.
IF WATER IS NOT FLOWING THROUGH THE
WATER PUMP:

intake nozzle.

the tubing is in the “ON” position.



IF THE CUTTING TABLE IS NOT SLIDING SMOOTHLY:
guide rails.
If problem continues, call our Customer Service
Department at 1-866-435-8665.
4. Make sure the in-take sponge filter is cleaned after
each use.
5. Pump clean/ fresh water for one minute through the
water pump and the blade guard to prevent waste
build-up and clogging.
Do not run the pump without water.
Front plate
accessory
Sponge
Impeller
lid
Pump
shaft
Impeller
FIGURE 25
DIAMOND BLADES
1. Use only 10 in. wet continuous rim diamond blade
with this saw.
2. Arbor size is 5/8 in.—please choose the right size to
fit the inner flange.
3. Do not use wood sawing blade, or other blades not
suitable for ceramic, porcelain or stone—severe
body injury or the saw damage may occur.
4. This saw comes with a standard blade that is ideal
for cutting ceramic tile. If your project requires the
cutting of other substrates (ex. porcelain, slate,
stone), it is recommended that you use the specific
type of blade for the material being cut.
THE FOLLOWING ARE DIAMOND BLADE SAFETY
PRECAUTIONS:
for cracks or uneven wear.
Discard cracked, chipped or bent blades!
ALWAYS USE MANUFACTURER’S RECOMMENDATION
for matching the right blade with the right material
being cut.
 INSPECT THE ARBOR SHAFT for uneven wear before
mounting the blade.
ALWAYS USE BLADES WITH THE CORRECT ARBOR
SIZE on a compatible arbor shaft.
 ENSURE THE BLADE IS MOUNTED WITH THE
ROTATION ARROW IN THE PROPER DIRECTION and is
securely tightened with a wrench.