Use and Care Manual

– 10 –
STEP 4: Tighten the bevel adjustable knob when the
cutting head is positioned on the desired angle.
STEP 5: Turn on the power and make bevel cuts by
pushing the cutting table toward the cutting head.
Bevel
adjustable
knob
45°–90°
FIGURE 21
FIGURE 22
MAINTENANCE
DO NOT SERVICE, CLEAN, OR
MAINTAIN THE SAW WITHOUT FIRST TURNING OFF
THE MOTOR AND UNPLUGGING THE SAW FROM ITS
POWER SOURCE. FAILURE TO DO SO MAY RESULT IN
SERIOUS INJURY TO THE OPERATOR.
MOvING ThE SAW
Before moving the saw, be sure to tighten the
slide tube locking knob (FIGURE 17), to prevent main
working table from sliding randomly during transport.

site, unlock the wheels on the bottom of the stand and
move the saw with the stand attached.

saw from the stand and use the wheels on the saw
frame (FIGURE 23). The stand folds up separately for
easy transport (FIGURE 24).
FIGURE 23
FIGURE 24
CLEANING ThE SAW
For the long life and best performance of saw:


clean and free of debris.


overheating.

side extension table tubes after each use.
NOTE: NEVER attempt to service the internal parts of
the motor. Contact our company’s Customer Service
Department for any motor function problems or failures.
WATER PUMP MAINTENANCE
DISCONNECT THE POWER
BEFORE MAINTENANCE OF THE PUMP.
1. Disassemble the water pump to see if any cracks or
dirt are inside (FIGURE 25).
2. Check if the water tubing is clogged where the water
cannot flow. Clear the tubing with warm water.
3. Make sure pump is plugged in during use.