SDS

BRUSHTOX WITH TRICLOPYR SAFETY DATA SHEET
Page 3 of 6
SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
EXPOSURE LIMITS (8 hour TWA, ppm):
COMPONENT
OSHA PEL
ACIGH TLV
Triclopyr BEE ester
Not listed
Not listed
Naphthalene
10 ppm
10 ppm
ENGINEERING CONTROLS: Proper ventilation is required when handling or using this product to minimize exposure
to airborne contaminants. Local mechanical exhaust ventilation may be required. Facilities storing or utilizing this
material should be equipped with an eyewash facility and a safety shower.
PERSONAL PROTECTIVE EQUIPMENT:
EYE PROTECTION - Safety goggles, face shield or full face respirator if vapors cause eye discomfort.
CLOTHING - Long-sleeved shirt and long pants, Shoes plus socks.
GLOVES Chemical resistant gloves such as barrier laminate, butyl rubber, nitrile rubber, neoprene rubber, polyvinyl
chloride (PVC) or viton.
RESPIRATOR - When handling in enclosed areas use a respirator approved for pesticides.
Discard clothing and other absorbent materials that have been drenched or heavily contaminated with this product's
concentrate. Do not reuse them. Follow manufacturer's instructions for cleaning/maintaining PPE. If no such
instructions for washables, use detergent and hot water. Keep and wash PPE separately from other laundry.
USER SAFETY RECOMMENDATIONS:
Wash hands before eating, drinking, chewing gum, using tobacco or using the toilet. Remove clothing immediately if
pesticide gets inside. Then wash thoroughly and put on clean clothing. Remove PPE immediately after handling this
product. Wash outside of gloves before removing. As soon as possible wash thoroughly and change into clean
clothing.
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Light yellow clear liquid
Odor: Paint like odor
pH: 3.65 4.65
Melting Point: Not applicable
Boiling Point: No data
Flash Point: 5C
Evaporation Rate: No data
Flammability: No data
Flammability Limits: No data
Vapor Pressure: 0.2 mPa (25°C) (Triclopyr)
Vapor Density: Not applicable
Density: 1.15 1.21 g/ml (9.60 10.10 lb/gl)*
Solubility: Emulsifies
Partition Coefficient: log P
ow
= 0.42 (pH5), -0.45 (pH7), -0.96 (pH9) (Triclopyr)
Auto-Ignition Temperature: No data
Decomposition Temperature: No data
Viscosity: 14.49 cSt (20°C); 6.7 cSt (40°C)
*Listed density is an approximate value and does not necessarily represent that of a specific batch.