Warranty Guide

Rev: 5 06/2016 Brush Master™ Chipper/Shredder with 2-Way Feed
12
T
Assembly
8. Attaching the chipper discharge chute (Figure 3)
Place discharge chute over rectangular opening on the
chipper body. The plastic discharge chute fits on the
outside of the steel chipper body.
The steel liner inside the plastic discharge chute also fits
outside of the steel chipper body.
Attach with four 20mm long bolts with lock washers and flat
washers. No nuts required for these connections.
Figure 3
9. Attaching the lower leaf funnel section. (Figure 4)
The plastic part has a hook shape on the bottom side. The
hook shape slides into the steel track on the chipper body.
When the two parts have been connected, fasten with three
20mm long bolts, a flat washer on each side, and nylon nuts.
Figure 4
Figure 5
10. Attach the handle section and leaf funnel base to
the upper leaf funnel with entry shield.
First attach the upper funnel section to the lower funnel
section and align using the large round protrusions and
holes. Insert two bolts (one in each side) in the holes clos-
est to the engine.
Second spread the open end of the upper funnel section
and insert the handle section in the slot on both sides.
Third fasten the components together with the remaining 8
fasteners. Each bolt should have two flat washers and a
nylon nut.
11. Re-connect the spark plug wire
12. Add oil and fuel.
30mm bolts fasten here
45mm bolts fasten here