Warranty Guide

Rev: 5 06/2016 Brush Master™ Chipper/Shredder with 2-Way Feed

5. Disconnect The Spark Plug Wire

Before setting up your chipper shredder, disconnect the

spark plug wire from the spark plug and ground against the

engine to prevent inadvertent starting of the machine. This

step should be taken as a precaution whenever you are

working on this machine.

Assembly

6. Attaching the chipper wheels (Figure 7)

First remove the spring pin and washer of right and left whe

el shift, then assemble the two wheel on right and left wheel

shift, and fasten at outside of the wheel with the removed

spring pin and washer.

Figure 7

7. Attaching the lower leaf funnel section. (Figure 6)

Assemble foot support on the position where no fasten bolt

of the front housing, there's reserved standard parts on it,

left side fasten with two M8*20 bolt, 4 washer, 2 lock nut,

right side fasten with 2 M8*25 bolt, 4 washer, 2 lock nut.

Figure 6

4. Verify all parts are in the hardware bag (Figure 2)

 Goggles (eye protection)

 Wrenches for assembly and blade maintenance

 Allen wrench for blade maintenance

 Oil funnel with flexible neck

 Spark plug wrench

 Owner’s Manual

 Hardware: eleven 20mm long bolts, two 30mm long bolts,

two 45mm long bolts, 26 flat washers, 4 locking washers

and 11 nylon locking nuts

Bolt Identification:

Place top of bolt head here

Actual Size

20mm

45mm 30mm