Warranty Guide

Rev: 5 06/2016 Brush Master™ Chipper/Shredder with 2-Way Feed
10
T
Assembly
IMPORTANT: This unit is shipped without gasoline or oil in
the engine. Be certain to fill the engine with gasoline and oil as
instructed before operating your machine.
Required tools: Two 13mm wrenches
NOTE: Both wrenches are supplied in the hardware bag.
Approximate assembly time: 15 minutes
1. Remove the chipper from its carton
Remove plastic banding and cut the tape on the top of
the box.
3. Verify all chipper components are present (Figure 1)
Item 1: Engine/chipper body/wheels subassembly (CH6
and CH8 only)
Item 2: Lower leaf funnel section
Item 3: Upper leaf funnel section with entry shield
Item 4: Handle section and leaf funnel base
Item 5: Discharge chute with deflector
Item 6: Support foot with rubber foot (CH10 and CH11
only)
Item 7: Wheels (CH10 and CH11 only)
Item 8: Shipping frame(CH6 and CH8 only)
Figure 2
2. Remove the shipping frame (item 8) from item 1(CH6
and CH8 only)
The steel shipping frame (item 8) is banded to the base of
the chipper at the engine mounting location. Cut these
bands with scissors or a knife to remove the chipper from
the shipping frame. The shipping frame can be discarded.
Figure 1
1
2
3
4
5
8
6
7