Specifications

Refresh Button
- Loads the Track again and replots it. Useful if you load a new track into a track
number and want to view it without having to restart the Track Profile dialog.
Track Filter
The Track Filter provides the ability to reduce the number of points in a track by selectively
removing points using the specified parameters.
The best filter setting is the one which produce the smallest number of points but still retain a good
representation of the original track.
The track can be filtered using the Filter Index method or the Number of Points method.
From Track
- The track number you want to filter.
To Track
- The track number where the filtered track is to be placed.
Filter Index
- If this method is selected, the higher the index the less points in the filtered track.
(default setting = 5).
Number Points
-
If this method is selected, the track will be filtered to the number of points entered.
(default setting = 100). The number of points produced may not exactly match the number specified
but will be close.
Filter
- Press this button to create the filtered track.
Points
see also Point Properties Point Set Properties Point Control
Do not confuse points with waypoints they are not the same type of object, it is suggested that you
also read the section on Waypoints to fully understand the difference.
A point is also not related to a track point, they are a different type of object.
Definitions
Point
-
A position on the map which has as its main properties a position and a name. All other
Page
190
of
252
OziExplorer Help Contents