Specifications

Section 5:
System & GPS Setup Options
Alarms
This unit has several GPS alarms. The factory default setting has all the
alarms turned on. You can turn the alarms off and on and change their dis-
tance settings.
You can set an arrival alarm to flash a warning message and sound a tone
when you cross a preset distance from a waypoint. For example, if you
have the arrival alarm set to 0.1 mile, then the alarm will flash a message
when you come within 0.1 mile of the recalled waypoint.
The off course alarm warns you when your track drifts too far to the right or
left of the course line to the waypoint. For example, if the alarm is set to 0.1
mile, then the alarm flashes a message if you drift 0.1 mile or more to the
right or left of the line to the waypoint.
The anchor alarm is triggered when you drift outside of a preset radius.
Again, using the 0.1 mile as an example, if you're anchored and your boat
moves more than 0.1 mile, the alarm will flash a message and sound a
tone.
You can only adjust alarm distance settings or turn alarms off or on in Ad-
vanced Mode. (Switch from Easy to Advanced:
MENU|↓ to ADVANCED
MODE|ENT|←|ENT.)
Alarms command, left; Alarm menu, right.
To change alarm settings:
1. Press
MENU|MENU|↓ to ALARMS|ENT.
2. Scroll ↓ or ↑ to select the desired category, then press
ENT to check or
clear the enabled box. This turns the alarm on (checked) or off (unchecked).
3. To change distance settings, scroll ↑ or ↓ to select the desired category,
then press
ENT to activate the distance dialog box. Press ↑ or ↓ to change
the first character, then press → to the next character and repeat until the
distance is correct.
65