Installation guide

Aftermarket LCD Upgrade Manual
P/N 400-283-301 Rev A 47
5. If you are experiencing “tearing” on the top of
your screen (in VGA mode) you may need to
adjust the coast start and coast end. Please
follow the directions in section 8.1.1 (steps 1 & 2)
to get to this screen. At the Video option, press
the right arrow.
Make note of what the values are for both of
these settings as it is possible to over adjust
them which may result in a loss of the display. If
this occurs, reset the values to what they were
prior to any changes. You may need to reset the
display by selecting another input source (select
S-Video then go back to VGA).
8.1.3 Common Adjustments
The screen at right is found when you have selected
the Power Setting option (see picture for S-Video
section 8.1.1 step 8).
Set Power On Mode to Last and Auto Power Off to
Off.
This completes the necessary adjustments for your new monitors and your scoring system.
If any other adjustments are required, please refer to the manual supplied with your
monitors, or call QubicaAMF Technical Support at 866-460-QAMF (7263).