Installation guide

Appendix A – Using the Troubleshooting Screens 93
Stage 3. Setting Pins
This stage represents the expiry of the Score Taken to Pins
Set timer. It is at this point the Duo software will start looking
to see when the image has stopped moving and the cycle
has completed.
Again, this timer can be adjusted from the Fine Tune the
Scoring Setup screen, but they have been pre-configured
for each type of Pinsetter and should not need to be altered.
In this example, the default Delay from Pins Set to
Pinsetter at Rest is 3.0 seconds. Therefore, the next stage
(Event) will occur at that time.
Stage 4. Scoring Cycle Ended
The final stage represents when the Pinsetter has completed
its cycle, either by observing that all movement has finished,
or by the expiration of the Pins Set to Pinsetter at Rest
timer, whichever occurs first.
Again, this timer can be adjusted from the Fine Tune the
Scoring Setup screen, but they have been pre-configured
for each type of Pinsetter and should not need to be altered.
Things to Check
If you are having scoring issues, check the following areas:
1. Check that the Pinsetter has finished it’s cycle and is
stationary in the image. If the machine is still in motion,
you can extend the Delay from Pins Set to Pinsetter at
Rest in the Advanced Tuning Screen.