Installation guide

Chapter 10: Install and Configure the Software 72
&KDSWHU,QVWDOODQGFRQILJXUHWKH6RIWZDUH
Once all printers have been installed and tested and the networking connections have been tested on all
computers, you can proceed to installing the Center Command software suite.
1. Install the Software on the Master Computer
Insert the installation CD into the MASTER computer and you will be presented with the following screen.
Click on the Full Program Installation button and follow the prompts to install the initial program files. Once
this is done there will be a Computer Score icon on the desktop of your computer. Double click on this icon to start
the software.
2. Register the Software
Once the software is running, you must then tell the computer what the name and address of the center is. To
do this, click on the System Management menu button and then select F4 Register Software.
Click on the Register button and enter your center’s details including the exact name of the center as given to
your supplier for registration purposes.
Then enter the registration number as given by your sales representative and click on the OK button.