Installation guide

Chapter 7: Plug In and Setup 47

Dual Wired Keypads

Remove the battery pack connector and plug in the LLAN cable from the Duo CPU Module into the LLAN IN

connector on the Keyboard PCB (Printed Circuit Board) of the Odd Lane.

Then, run a short LLAN cable from the LLAN OUT of the Odd Lane, through the steel keypad stand to the

LLAN IN of the Even Lane’s keypad.

Then you must set the Channel Number on the Rotary DIP Switches to:

 01 for the Odd Lane. (Zero on the 10’s switch and One on the 1’s switch)

and

 02 for the Even Lane. (Zero on the 10’s switch and Two on the 1’s switch)

This is so the keypad can send a signal for left or right lane via the LLAN plug, every time a key is pressed.