Installation guide

Chapter 2: Run the Cables – Type A 30
VIA Pinsetter
Run both the DMO-VIA (Odd Lane) and DME-VIA (Even Lane) cables from the Duo Camera Module, along
the Ball Track, up the kickback, and then up to the cable tray at the front of the Odd and Even lanes respectively.
Make sure you route all cables away from moving parts, so there is no chance of the cables being crushed or cut.
All connections go to a single 15 pin plug on the MC2 Scoring Interface board, located in the cable tray.
See your VIA reference material to determine for more information on the location and connection to the MC2
Scoring Interface Board.
1= Scoring Interface Connector DB15 Male
Note: In order for the Duo system to operate with the VIA pinsetter, you MUST set
the machine type to XIMA in Step 2 of the lane setup wizard. This is because
the XIMA and the VIA pinsetters operate in a very similar manner, with only
the electronics being the major difference.