Installation guide

Chapter 2: Run the Cables – Type A 28
Xima Pinsetter
Run both the DMO-XM (Odd Lane) and DME-XM (Even Lane) cables from the Duo Camera Module, along
the Ball Track, up the kickback, and then up to the Control box on the Odd and Even lanes respectively. Make sure
you route all cables away from moving parts, so there is no chance of the cables being crushed or cut.
The start contacts are connected in series to the managers control switch and the cycle contact is wired in
parallel to the cycle button from the ball return.
See your Xima reference material to determine for more information on where to connect into the Xima
Control chassis.
Note: The Duo unit’s start contacts must be connected in series (in line) not in
parallel with (across) the manager’s control switch. This is to ensure that when
the manager’s control switches are switched off the pinsetter will turn off.
Normal operation will see the Manager’s control switch turned on, the
pinsetter will turn on and off with the games bowled. If, however, there is an
urgent need to turn the pinsetter off it can be done quickly using the
Manager's control switches.