Installation guide

Chapter 2: Run the Cables – Type A 15
AMF 82-30
Run both the DMO-30 (Odd Lane) and DME-30 (Even Lane) cables from the Duo Camera Module, along the
Ball Track, and up the kickback to the Odd and Even lane Pinsetter respectively.
The Start cable is wired to the “P” Box at the front of the machine and the cycle cable is wired to the “J” Box.
Again, the start contact is wired in series to the managers control switch and the cycle contact is wired in parallel to
the cycle button from the ball return.
Warning: Beware of high voltage present in the J Box. You MUST turn off AND
isolate the pinsetter BEFORE working on it.
Warning: You MUST NOT connect the foul to the Duo Scoring Module or YOU
WILL DAMAGE IT. Many 82-30 machines use a high voltage foul
signal. Duo accepts the low voltage foul signal only.