Installation guide
Appendix C - AMF Manager’s Control Unit connection 108
Installing the MCU Interface Controller
To install the Windows Bumper Interface controller, there are three basic stages:
A. Install driver for USB to RS232 converter
B. Create a Startup Shortcut
C. Setup the Center Command Software
There are several steps in each of these stages, however anyone with a good general knowledge of Windows
can perform them.
A. Install driver for USB to RS232 converter
1. Insert USB plug into a free USB socket at the rear of the computer. Wait for the “Found New Hardware” wizard to
appear.
2. The computer will automatically search for a software driver, but will probably not find one. If this is so, select the
option to browse for the correct driver.
3. Insert the Center Command Installation CD into the CD drive. When the Computer Score Setup program starts,
cancel it.
4. In the Found New Hardware Wizard, click on Browse and navigate to the
Drivers\ADAM-4561 4562 USB to Serial\98_2K_XP_VISTA folder on your CD drive.
5. When the screen stating that “Windows can’t verify the publisher of this driver software” appears, click on the
Install this Driver Software Anyway button.
6. When complete click finish.