Installation guide

Appendix B – Automatic Bumpers 104
2. Setup Duo CPU Module
The Duo CPU Module must be configured to control automatic bumpers. This is done from Step 3 of the Setup
Wizard as described in the “Using the Setup Wizard” section of this manual.
3. Setup Center Command
1. Make sure that the Duo units have Automatic Bumpers enabled, as described in Step 3 of the Setup Wizard.
2. Run the Center Command software and go to the System Management menu and click on Control Setup.
3. When the Control Setup screen appears, click on the Center Setup tab.
4. Click on Edit and change the Bumpers drop down list to Brunswick Bumpers.
5. Place a Tick in the field Name entry required after Start Open Play
6. Save and exit Center Command back to Windows
7. Run Center Command again to activate the bumper functionality.