Installation guide

Appendix B – Automatic Bumpers 103
1. Configure the Brunswick Bumper Controller
Each Bumper Controller, which is located under each lane pair, approx. mid way up the lane, must be
configured to Frameworx mode in order to function with the Duo system.
To do this, follow these steps:
1. Pull out the power cable to isolate the Brunswick Bumper Controller and make it safe to work on.
2. Remove the top cover of the Controller.
3. Set all 8 Switches on DIP Switch S1 to the OFF position.
4. Ensure jumper on JP1 is set to U (Un-terminated)
5. Replace the top cover of the Controller.
6. Plug the power cable to re-activate the controller.