Installation guide

Appendix A – Using the Troubleshooting Screens 96

Synchronise the frame to 1

Ball

This button will enable or disable the failsafe feature called FrameSync. FrameSync is usually set ON.

FrameSync is a method of making sure that the Pinsetter and the Duo unit are both on first ball or second ball,

by looking at the action of the Pinsetter to see if the Pins are picked up (First Ball) or wiped away. (Second Ball) If the

Duo is on second ball and a first ball score is detected, then the new score will overwrite the old one, making sure that

the Pinsetter and the Duo are both now on second ball.

Adjust Camera

Duo allows you to have the option of a second camera that captures video of the bowler’s form at the foul line,

when delivering the ball. If this 2

camera is present, then the first screen shown when selecting the Adjust Camera

function allows you to select which camera you would like to adjust.

Make sure that the correct camera image is being shown in the correct location. If the wrong image is being

shown, (Eg: Score Camera Image being shown in the Player Camera position) then you can swap the cameras by

pressing the C Key.

Press 1 to Manually adjust the Score Camera, Press 2 to adjust the Player Camera.

Note: If you do not have the optional Player Camera installed, then selecting the

Adjust Camera function will go straight into the Score Camera section, below.

Score Camera

The Advanced Camera Adjustments screen has three functions. All these functions should be correctly set

after completing the Setup Wizard. You should only change these settings from the default if you repeatedly

encounter scoring problems.

Select which lane to change by pressing the Move Cursor Left button for the Odd Lane or Move Cursor Right

for the Even Lane.

Find the Pins

Press the F button to automatically re-configure all the pins for the selected lane, the same as during the

Wizard. Often, if a Pin is incorrectly detected, then pressing F a second time will then correctly find the pin. It is very

rare to have to manually move the Pin Position Indicators.