Installation guide

Appendix A – Using the Troubleshooting Screens 95
Fine Tuning the Scoring Setup
The next option in the Troubleshooting Screen allows you to Fine Tune the Scoring Setup by modifying the
timing of the scoring software. Press the F button to enter this screen.
As already shown in the Reviewing the Last Score section of this manual, the scoring software relies on the
expiry of three timers to help determine the correct score at the correct time in the Pinsetter’s cycle.
Take Data Delay
The Take Data Delay is by far the most important timer for scoring reliability. This represents the amount of
time from when the Pinsetter’s cycle starts to when the score should be determined. This timer is preset for each type
of Pinsetter, and should only be changed if your Pinsetter is faster or slower than usual. A good example of this are
Brunswick A2 machines modified with a quick drop rake. This would require the delay to be set a little bit faster.
To make the delay shorter press the Move Cursor Left button repeatedly, to make the delay longer press the
Move Cursor Right button repeatedly. To set the delay back to the default amount for the selected Pinsetter, press
the D button.
To modify the other two timers, press the A button to view the Advanced Pinsetter Timings screen.
Advanced Pinsetter Timings
The Advanced Pinsetter Timings screen allows you to change the other two time delays in the scoring software
as already discussed in the Review the Last Score section. These time delays are preset depending on the type of
Pinsetter chosen in the Setup Wizard and should not need to be altered.
The only time they would need to be changed is if the images in the Review the Last Score screen show the
Pinsetter still in motion in Stage 4.
To change either timer, press 1 or 2 respectively and then press Move Cursor Left or Move Cursor Right
buttons repeatedly until the timer is at the desired length. Press D to set the delay back to the default time.