Safety data sheet

Page 8/14
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 02.04.2017 Revision: 02.04.2017Version number 6
Trade name:
BRUNOX® epoxy® (AEROSOL)
(Contd. of page 7)
44.3.9
Check the permeability prior to each anewed use of the glove.
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
Nitrile rubber, NBR
Butyl rubber, BR
The selection of the suitable gloves does not only depend on the material, but also on further marks
of quality and varies from manufacturer to manufacturer. As the product is a preparation of several
substances, the resistance of the glove material can not be calculated in advance and has
therefore to be checked prior to the application.
·
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and
has to be observed.
·
Eye protection:
Tightly sealed goggles
SECTION 9: Physical and chemical properties
·
9.1 Information on basic physical and chemical properties
·
General Information
·
Appearance:
Form:
Fluid
Colour:
Amber coloured
·
Odour:
Characteristic
·
Odour threshold:
Not determined.
·
pH-value at 20 °C (68 °F):
4.8
·
Change in condition
Melting point/freezing point:
Undetermined.
Initial boiling point and boiling range:
82 °C (180 °F)
·
Flash point:
13 °C (55 °F)
·
Flammability (solid, gas):
Not applicable.
·
Ignition temperature:
270 °C (518 °F)
·
Decomposition temperature:
Not determined.
·
Auto-ignition temperature:
Product is not selfigniting.
(Contd. on page 9)
GB