Safety data sheet

Page 6/11
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 02.04.2017 Revision: 02.04.2017Version number 16
Trade name:
BRUNOX® LUB & COR® (BULK)
(Contd. of page 5)
44.3.9
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
CAS: 123-95-5 Dermol BS
WES (New Zealand) Long-term value: 10* mg/m³
*inhalable dust: no asbestos, <1% free silica
·
Additional information:
The lists valid during the making were used as basis.
·
8.2 Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
Avoid contact with the eyes and skin.
Be sure to clean skin thoroughly after work and before breaks.
Do not inhale gases / fumes / aerosols.
Keep away from foodstuffs, beverages and feed.
·
Respiratory protection:
Use suitable respiratory protective device in case of insufficient ventilation.
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer
exposure use self-contained respiratory protective device.
Short term filter device:
Filter A/P2
Filter AX
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
Nitrile rubber, NBR
The selection of the suitable gloves does not only depend on the material, but also on further marks
of quality and varies from manufacturer to manufacturer. As the product is a preparation of several
substances, the resistance of the glove material can not be calculated in advance and has
therefore to be checked prior to the application.
·
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and
has to be observed.
·
Eye protection:
Safety glasses
GB
(Contd. on page 7)