Safety data sheet

ManualsBrandsBRUNOX ManualsCar CareTurbo Spray TURBO-SPRAY 100 ml

Page 6/12

Safety data sheet

according to 1907/2006/EC, Article 31

Printing date 02.04.2017 Revision: 02.04.2017Version number 13

Trade name:

BRUNOX® Turbo-Spray® (AEROSOL)

(Contd. of page 5)

44.3.9

8.1 Control parameters

Ingredients with limit values that require monitoring at the workplace:

CAS: 124-38-9 carbon dioxide

WEL (Great Britain) Short-term value: 27400 mg/m³, 15000 ppm

Long-term value: 9150 mg/m³, 5000 ppm

WES (Australia) Short-term value: 54000 mg/m³, 30000 ppm

Long-term value: 9000 *22500 mg/m³, 5000 *12500 ppm

*in coal mines

WES (New Zealand) Short-term value: 54000 mg/m³, 30000 ppm

Long-term value: 9000 mg/m³, 5000 ppm

CAS: 123-95-5 Dermol BS

WES (New Zealand) Long-term value: 10* mg/m³

*inhalable dust: no asbestos, <1% free silica

Additional information:

The lists valid during the making were used as basis.

8.2 Exposure controls

Personal protective equipment:

General protective and hygienic measures:

Wash hands before breaks and at the end of work.

Do not inhale gases / fumes / aerosols.

Respiratory protection:

Filter A/P2

Filter AX

Protection of hands:

Use gloves of stable material (e.g. Nitrile) - if necessary tricoted to improve the wearability.

The glove material has to be impermeable and resistant to the product/ the substance/ the

preparation.

Due to missing tests no recommendation to the glove material can be given for the product/ the

preparation/ the chemical mixture.

Selection of the glove material on consideration of the penetration times, rates of diffusion and the

degradation

Material of gloves

Nitrile rubber, NBR

The selection of the suitable gloves does not only depend on the material, but also on further marks

of quality and varies from manufacturer to manufacturer. As the product is a preparation of several

substances, the resistance of the glove material can not be calculated in advance and has

therefore to be checked prior to the application.

Penetration time of glove material

The exact break through time has to be found out by the manufacturer of the protective gloves and

has to be observed.

Eye protection:

Not required.

(Contd. on page 7)