Safety data sheet

ManualsBrandsBRUNOX ManualsCar Carerust-converting and primer EPOXY 100 ml

Page 7/13

Safety data sheet

according to 1907/2006/EC, Article 31

Printing date 02.04.2017 Revision: 02.04.2017Version number 5

Trade name:

BRUNOX® epoxy ( BULK )

(Contd. of page 6)

44.3.9

CAS: 64-18-6 formic acid

WEL (Great Britain) Long-term value: 9.6 mg/m³, 5 ppm

WES (Australia) Short-term value: 19 mg/m³, 10 ppm

Long-term value: 9.4 mg/m³, 5 ppm

WES (New Zealand) Short-term value: 19 mg/m³, 10 ppm

Long-term value: 9.4 mg/m³, 5 ppm

Additional information:

The lists valid during the making were used as basis.

8.2 Exposure controls

Personal protective equipment:

General protective and hygienic measures:

Keep away from foodstuffs, beverages and feed.

Immediately remove all soiled and contaminated clothing

Wash hands before breaks and at the end of work.

Do not inhale gases / fumes / aerosols.

Avoid contact with the eyes and skin.

Respiratory protection:

Use suitable respiratory protective device in case of insufficient ventilation.

In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer

exposure use self-contained respiratory protective device.

Short term filter device:

Filter A/P2

Filter AX

Protection of hands:

Protective gloves

The glove material has to be impermeable and resistant to the product/ the substance/ the

preparation.

Selection of the glove material on consideration of the penetration times, rates of diffusion and the

degradation

Check the permeability prior to each anewed use of the glove.

Material of gloves

Nitrile rubber, NBR

Butyl rubber, BR

The selection of the suitable gloves does not only depend on the material, but also on further marks

of quality and varies from manufacturer to manufacturer. As the product is a preparation of several

substances, the resistance of the glove material can not be calculated in advance and has

therefore to be checked prior to the application.

Penetration time of glove material

The exact break through time has to be found out by the manufacturer of the protective gloves and

has to be observed.

(Contd. on page 8)