Installation manual

SRE-2000C 11-14-2007

INSTALLATION

1. Determine whether the stairway elevator will be

installed on the right or left side of the stairs, as

viewed from the bottom of the stairs.

NOTE: Unless otherwise specied, Bruno Stairway

Elevators are shipped from the

factory set

for left-side installation.

If you wish to convert to right-side

installation, please refer to the instructions

appearing later in this manual.

2. Determine the exact rail length by placing a

tape measure in a straight line on the stairs

(see STEP 4 of the APPLICATION GUIDE).

3. To this number, add Measurement B (see STEP

4 in the APPLICATION GUIDE)

NOTE: If the unit is equipped with an over-

speed brake, add 5” to the rail length.

This calculation will allow you to precisely t the

Stairway Elevator to your customer by determining

the most comfortable seat-to-oor height within

the space available at the top of the stairs.

4. Mark the length on the rail, as determined in

the previous step.

NOTE: Be sure that excess length is cut off of

the LOWER end of the rail.

5. After marking, and BEFORE cutting the rail, cut

the cable channel back approximately 3 inches

from the mark to avoid having to cut through

the channel.

cut off excess from

bottom end of rail

FITTING THE RAIL