Installation manual

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2000C 11-14-2007
38
As shipped from the factory, the Electra-Ride
TM
Elite is set up for left-side installation (as viewed
from the bottom of the stairs).
To convert the unit for right-side installation:
ELECTRICAL
1. Make sure the circuit breaker switch on
the rear of the carriage is in the OFF
position.
2. Remove the back carriage cover and the left
side cover.
3. Set the No. 3 DIP Switch on the 4-ganged dip
switch to the ON position.
NOTE: When converting from a left-hand to a right-
hand installation (as viewed from the bottom of
the stairs), the length of the (3) black, ribbed
wire harnesses will increase when you change
the angle of the carriage.
Tuck these harnesses into the carriage.
DO NOT bundle them next to the circuit board
to avoid contact between the harnesses and
board components.
MECHANICAL
4. Loosen (but do not remove) the
bottom (M14) carriage bolt.
5. Remove the top (M14) carriage bolt.
6. Apply pressure with your hands to the top of
the carriage to pivot it to the opposite side.
7. Reinsert the top (M14) carriage bolt.
8. Tighten the top carriage bolt.
9. Tighten the bottom (M14) carriage bolt.
10. Reinstall back and side carriage
covers.
11. On the FRONT of the carriage,
remove the longer (M14) bolts ON THE LEFT
and the shorter (M14) bolts ON THE RIGHT.
CONVERSION TO RIGHT-HAND INSTALLATION
dip switches
• remove
longer bolts
• switch to
right side
• remove
shorter bolts
• switch to
left side