Installation manual

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2000C 11-14-2007
34
ELECTRICAL
Mounting the battery charger
1. Position the charger in a suitable
permanent location where it will not
create a tripping hazard.
2. Route the battery charger wiring
harness along the back side of the rail.
3. Secure this harness to the rail clamps
with wire ties.
4. Secure the charger in the chosen loca-
tion (Step 1) by inserting (2) screws
(provided) through the mounting holes
in the charger base.
NOTE: There are (2) mounting holes
on each side of the charger base.
Choose one of the two on each side.
5. Connect the power cord to the nearest
wall or oor outlet.
6. Connect the charger wiring harness to
the elevator power cable.
7. Bundle together loose wires.
8. Turn ON the charger power switch.
(continued on next page)
Choose one
of these (2)
mounting
holes
Choose one
of these (2)
mounting
holes
+
elevator
power cable
elevator charge
bumper
elevator charge
bumper
charger
power cord
connect charger
wiring harness
to elevator
power cable
charger power switch
NOTE: If the batteries become discharged,
the carriage will move more slowly
until the voltage drops to a point
where the controller will shut off.
In this event, pause for a moment,
then run the carriage "down" until it
engages the charge contacts.
Partially charged batteries will run
the carriage "down", but not "up".
Conrm that the charger is plugged
into a "live" outlet and wait for the
batteries to recharge.