Installation manual

SRE-2000C 11-14-2007

ELECTRICAL

LEARNING THE INFRARED TRANSMITTER

(not necessary when installing unit for the rst time)

continued

8. Clear the memory:

• Hold down the LEARN/ERASE button until the

LED goes out (approximately 12 seconds).

9. Press and hold the LEARN/ERASE button (LED

is on). As you continue to press the LEARN/

ERASE button, press either of the call/send

transmitter buttons until the LEARN/ERASE

LED goes out (approximately 2-5 sec.).

10. Release both buttons (LEARN/ERASE and

transmitter).

The remote is now “learned”.

11. Test transmitter operation:

• Depress either of the transmitter buttons.

• If the carriage moves, the new congura-

tion has been accepted and the transmitter

relearned.

• If the carriage does not move, repeat Steps

8 through 10.

12. Make sure all transmitters are set to the same

switch conguration.

13. Remount the transmitter back (remount on

wall if applicable).

14. Remount and secure the carriage cover.