Installation manual

29
SRE-2000C 11-14-2007
©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
• Train the customer to use
the stairway elevator
correctly and safely.
• Have the customer operate
the unit while you are there
to answer questions and
address concerns.
• Remind the customer to
always use the seat
positioning belt.
A slight delay will occur between the time
the rocker switch is depressed and the start
of carriage movement.
This is normal and is a function of the soft
start feature of the controller.
1. Run the unit up and down the stairs using
the rocker switch on the carriage.
NOTE: The unit should operate in such a
way that the arrow depressed on the
rocker switch corresponds to the
desired direction of travel.
The unit should travel noticeably
faster going up than down.
2. Run the unit up and down the stairs using
the call/send transmitters.
3. Test both transmitters.
4. Push the seat into the folded position and
run the unit up and down the stairs with
the call/send transmitter.
5. With the seat in the central riding position,
move the elevator completely down and
up the rail, while observing the elevator-
to-wall clearance.
A clearance of
1/2" to 1" (13-25 mm)
is acceptable.
6. Repeat the run with the seat in the folded
position. If necessary, adjust the rail
placement by sliding it closer to, or
further from the wall.
7. Verify proper operation of the following:
speed, direction, nal limit switch, foot-
rest safety switch, seat swivel safety
switch, and remote call/send transmitter.
Testing the Call/Send Transmitters
ELECTRICAL