Installation manual

27
SRE-2000C 11-14-2007
©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
ELECTRICAL
INFRARED CALL/SEND TRANSMITTER
The call/send system on the Bruno SRE-2000C
is based on infrared (IR) controls, the same type
of control used for televisions and stereos.
Like a television remote, the SRE-2000C hand-
held transmitter may experience certain types of
interference.
Receivers are mounted on both sides of the SRE-
2000C carriage to minimize interference.
Should interference occur, the unit will stop. This
feature has been integrated into the SRE-2000C
to ensure your safety.
The direct line between the transmitter to either
of the (2) transmitters should be clear of obstacles
for optimal operation. It may be necessary to
reposition the transmitters so that they are
aimed at the carriage.
To reduce the possibility of interference:
• While riding in the seat, ALWAYS operate
the Elevator using the rocker switch on the
armrest.
• Operating the SRE-2000C with a trans-
mitter while riding in the seat can lead to
signal interference.
• DO NOT mount the transmitters behind an
obstacle such as a rail post.
• DO NOT allow direct sunlight to shine on
the receivers (blinding the receivers on the
carriage).
• DO replace transmitter batteries regularly.
• Depleted or nearly-depleted batteries alter
the effective range of the transmitter.
• DO keep the transmitter and receiver lens
free of dirt and debris.
• Use a non-abrasive cleaner suitable for
glass or acrylic surfaces.
• Do not use polishes or cleaning products
containing wax. These products will leave
a lm on the lens that will reduce the
signal transmission range.