Installation manual

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2000C 11-14-2007
26
Mounting the nal limit ramp kit
The nal limit ramp kit is a safety
feature which enhances the stopping
capability of the Electra-Ride™ Elite.
It mounts on the top rail section, on
the side facing away from the stairs.
1. Before installing the nal limit ramp
kit, run the carriage down a foot or
two to provide greater access to the
mounting hardware.
2. Mount the nal limit ramp kit on
the bottom side of the rail as shown
below.
3. Using the holes for the ramp and/or
the slotted adjustment bar and block
allows for ne adjustment of the
position of the nal limit ramp kit
in relation to the clamp on the top
step.
4. To attach the block to the rail, tighten
the (2) M6x1x30mm bolts ONLY.
5. To secure the adjustment bar,
tighten the (2) M6 nuts on the
M6x1x30mm bolts.
nal limit
adjustment bar
adjustment slot
INSTALLATION
nal limit adjustment block