Installation manual

SRE-2000C 11-14-2007

Mounting the seat assembly

front

cover

mount

1. Slide the seat post assembly between the footrest

assembly mounting plate and the footrest lever.

2. Secure the seat post assembly:

• UPPER HOLES: Secure with two (2) M10 x 1.50 x

20mm lg hex head cap screws, (2) at washers and

(2) lockwashers.

• LOWER HOLES: Install the front cover mount with

two (2) M10 x 1.50 x 20 mm lg head head cap

screws and (2) lockwashers (no at washers).

3. Route the wire harness of the carriage contact assembly

through the front cover mount as shown.

4. Connect the two ends of the wire harness.

seat post assembly

outlined in black for

illustration purposes

connect wiring harness

upper

lower

INSTALLATION