Installation manual

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2000C 11-14-2007
22
INSTALLATION
Adjusting the carriage angle
1. Using the remote, verify that the
carriage travels smoothly down and
back up the rail.
2. When the carriage is at the top of the
stairs, check that it is level.
Use a builder’s or protractor level.
3. Adjust the carriage angle, if necessary,
to make the unit level.
• Loosen the two (2) M14 bolts on the
carriage subassembly with a 22mm
open-ended wrench.
• To access the second bolt, remove the
back main carriage cover. Gently apply
downward pressure on the right or left
side of the carriage, as needed to re-
turn the carriage to a level condition.
4. Retighten the 2 bolts.
5. Recheck with the level.
Remove main loosen (2) M14
bolts to adjust carriage angle
back carriage cover.
Now that the carriage is securely mounted
on the rail, check the clearance between the
antenna and the closest obstruction (wall,
handrail, windowsill, base of railing).
Verify that unit is level.
Checking the wall clearance