Installation manual

21
SRE-2000C 11-14-2007
©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
INSTALLATION
Mounting the carriage, upper bumper
and upper end cap
1. Lift and tilt the carriage as you guide
the carriage wheels onto the rail.
The newly-designed rail features
a recessed gear rack to facilitate
feeding the carriage onto the rail.
2. Turn on the circuit breaker.
3. Once you feel the carriage begin to
engage the gear rack, USE THE
REMOTE to nish feeding the
carriage onto the rail.
Make sure the remote is pointed
at the sensor (see illustration).
3. The remote will feed the carriage
smoothly onto the rail , and at the
proper speed to ensure that the gear
rack and carriage mesh correctly.
4. Mount the upper bumper assembly
and the upper end cap.
Use the remote to
fully engage the
carriage on the gear
rack.
sensor
recessed gear rack
for easier mounting
of carriage onto rail
The ON/OFF switch is built into the circuit
breaker and is provided to protect the battery,
controller and motor circuits in the stairway el-
evator carriage.
It is unlikely that this circuit breaker will trip in
normal use. However, should the elevator fail
to operate, check the circuit breaker as a rst
troubleshooting step, and reset it if necessary.
Bruno recommends that you determine the
reason that the breaker tripped, and correct the
situation.
Most frequent causes of a tripped circuit breaker:
1. foreign object jamming the rail or gear
rack, and
2. exceeding the rated load capacity leading
to circuit overload of the elevator.
circuit breaker with built-in
on/off switch
Circuit breaker