Installation manual

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2000C 11-14-2007
20
1. Once the clamps are in place, and secure,
and after verifying that the rail bottom is at
least 1-1/4” (32 mm) from the bottom of the
rail, and that the rail is straight, insert the
power cable into the channel that runs along
the back of the rail (side closest to the wall).
2. Determine the location of the wall outlet.
Start inserting the cable (i.e., pigtail of the
charge harness) at the end (top or bottom)
closest to that outlet.
NOTES: • Position the battery charger at this
end.
• When routing the cable around the
joint plate, make sure that the cable
rests snugly at against the rail
(see illustration to left).
Notice that the end of the cable opposite the
pigtail harness has been split slightly, and in-
cludes one male and one female connector.
The sheathing of one lead is ribbed (nger is
pointing to ribbed sheathing). The other lead’s
sheathing is smooth.
The ribbed lead attaches, via FEMALE connector,
to the RED positive charge lead.
The smooth lead attaches, via the MALE connector,
to the BLACK negative charge lead.
• Increase the split
• Cut off approximately the length shown below.
• Discard the old connectors.
• Strip the freshly cut wire ends.
• Install the new connectors provided in the kit.
• Connect the two wires to the charger bracket.
• Gently tuck the wires in the bumper assembly.
• Attach the bumper cover.
cut to length
strip wire ends
tuck wires into
bumper assembly
attach bumper cover
cable at against rail
smooth to
black (-)
male
rib to
red (+)
female
INSTALLATION
Routing the cable
routing the cable