Installation manual

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2000C 11-14-2007
18
11. Tighten the clamp hardware enough
to render the upper rail immobile. Do
not fully tighten at this time.
12. Once the rail sections are installed,
tighten the clamps.
13. BEFORE mounting the carriage, check
the straightness of the rail over all of
the stairs by using a level, or a plomb
line along the rail.
If the rail bows or leans forward,
insert shims or readjust the clamps.
14. Secure 2 or 3 of the rail clamps to the
stairs.
Secure the back half of the clamps rst.
The rail should be located 2-5/8” (67
mm) from the closest obstruction and
the back of the rail.
INSTALLATION ON CARPET
Before securing the rail clamps with
hardware, seat them using a deadblow
hammer. Use a rubber mallet to compress
the rug and pad before anchoring the
clamp to the step.
BACK FOOT OF CLAMP
(3 HOLES)
As you tighten the
clamps around the rail
sections, regularly
check that the rail is
vertical
or leaning backwards.
Rail section MUST be
at a 90-degree angle
to the stairs, OR
leaning BACK slightly.
The rail section must
NEVER lean forward.
INSTALLATION