Installation manual

©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2000C 11-14-2007
16
4. Place the upper section of the rail in the
clamps placed in Step 1.
When the rail is inserted between the clamp
halves, it will rest on the clamp spacer (see
illustration, previous page).
5. Slightly loosen the (3) M8 hex head screws
and the (2) M6 Allen head screws securing
the joint plate to the rail.
This makes it easier to align
the screws and the holes on
the mating rail section.
6. Gently slide the upper rail section up or
down the stairs until it mates with the lower
section so that the mating ends t ush.
7. From the kit provided, insert the (2)
M6x1x45 mm Allen head and the (3)
M8x1.25x16 mm hex head screws into the
appropriate holes in the joint plate. DO NOT
TIGHTEN.
NOTE: If the M6 Allen head screws do not line
up with the gear rack threads, loosen
all of the M5 set screws (two turns
only) to allow the gear rack to slide just
slightly in the rail, and permit alignment
of the M6 screws and the gear rack
threads.
8 Before tightening the hardware:
• check that the screw and rail/gear
rack threads are properly engaged;
• make sure the rail sections are ush.
slightly
loosen
x 5
It may be helpful to apply a
small amount of silver anti-
seize material to the hardware
threads before inserting.
9. Order of tightening hardware is important!
• FIRST tighten the (4) M6 Allen head screws
engaging the gear rack.
• Then tighten the (6) M6 hex head screws.
10. Slide the top and bottom clamps up or
down on the rail until they are rmly
seated on the step.
Tighten us rst!
INSTALLATION