Installation manual

15
SRE-2000C 11-14-2007
©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
INSTALLATION
1. Place rail clamps on the stairs in the following
pattern (LONGER-footed clamp to the outside).
Placing the rail clamps and rail sections
two at the bottom
two in the middle (one
on each side of rail joint)
2. Mount the bottom rail section in between the clamp
halves. Tighten the hardware enough to render the
rail immobile.
Do not fully tighten at this time.
3. Once the bottom rail section is mounted in the clamp
assemblies, rest the bottom of the rail against the
step noses at a distance from the wall of approxi-
mately 6” (15 cm).
NOTE:
Insert the
hardware so
that the nut is
closest to the
wall.
NOTE:
When the rail is
inserted between
the clamp halves,
it will rest on the
clamp spacer.
ridge of spacer
DOWN
two at the top*
“B” LOCK CLAMP
• bottom landing
• rst tread up from bottom landing
• top landing
• rst tread down from top landing*
(no clamp on top step/landing
for unit with standard extension)
• closest tread above and below rail joint(s),
then
• minimum of every third tread over the
remainder of the staircase.
*A minimum of (1) clamp must be installed beneath
the B LOCK CLAMP (secured to the oor or step).
After the rail is installed, drill through rail (using
holes in top of B clamp as guides) with a 1/4 in. bit.
Install M6 hardware, with nut on wall side of rail
(see exploded view at rear of manual).