Installation manual

SRE-2000C 11-14-2007

INSTALLATION

1. BE SURE TO WEAR PROTECTIVE GLOVES

AND EYEWEAR.

During the cutting process, sparks will y and

the metal rail will become very hot.

2. Place at side of the rail on the saw bed. Care-

fully align the saw to the line marking the de-

sired nished length of the rail.

3. For a precise and efcient cut, Bruno recom-

mends the use of a chop saw*.

A down-up motion during the cutting process

helps avoid overheating the saw motor.

*NOTE: The chop saw (or other power

saw) must be equipped with

metal-cutting blade suitable for

aluminum and steel.

4. Once the rail is cut, deburr the cut end using a

le or other appropriate tool. Soften any sharp

edges which might abrade the insulation of the

wiring routed to the bumper at the rail end.

5. Place the metal template (provided) on rail as

shown. Hold in place. Using a 1/8 in. bit, drill

two pilot holes. Switch to a 5/16 in. bit and re-

drill the (2) holes.

6. Install the lower bumper assembly and end cap

using the hardware provided.

You may wish to place a piece of cardboard or

a non-skid rug under the end of the bottom rail

to protect the oor and to keep the rail section

from sliding off the stairs.

template on rail

Cutting the rail and installing the lower bumper (con’t.)

at side of rail to saw bed

align saw with mark

up and down motion

lower bumper assembly