Installation manual

SRE-2000C 11-14-2007

IMPORTANT NOTE!

Under no circumstances should a rail section be cut shorter

than 18 in. (46 cm).

There must be at least (2) clamps on a short rail section (1 at

the rail joint and 1 at the rail end). Cutting a rail shorter than

18 in. (46 cm) would not allow enough room for the

(2) necessary clamps.

Example:

After measuring the staircase, you determine you need 9 feet of

rail. With your (2) 8-foot sections you decide to use

(1) 8-foot section and cut the remaining (1) foot from the

second 8-foot section.

Doing this could yield a rail piece with insufcient weld.

Instead, Bruno recommends cutting at least one foot off one of

the 8-foot sections (leaving 7 feet of rail) and then cutting

2 feet from the second 8-foot section. You will have a (1) 7-foot

section and (1) 2-foot section, both of which are long enough to

be properly mounted (2 clamps minimum per short rail).

Cutting the rail and installing the lower bumper

NEVER CUT OFF THE JOINT END!

The M6 bolts securing the gear rack must remain intact.

Cut off the end with the pre-drilled charge contact mounting holes.

Then, using the provided template, redrill (2) holes on each end of the rail.

INSTALLATION