Owner`s manual

LP Tank Leak Test
 Only propane gas is intended for use with this burner. Never use natural gas; the burner will not
operate properly.
 Every time your burner is attached to a gas cylinder, the Gas Leak Test must be executed.
 Anything that can easily ignite, such as matches, lighters, sparks and lit cigarettes must be k
ept away
from burner when performing the Gas Leak Test. Never use a flame to test for gas leaks.
 Never perform Gas Leak Test indoors. It must always take place outdoors in a well-ventilated area.
 All cookware must be removed from the cooker top before you perform the Gas Leak Test.
PROCEDURE:
 Rem
ove all cookware from the cooker top.
 After connecting the regulator to the gas cylinder, make sure gas cylinder valve and regulator are
off. Rotate the gas cylinder valve clockwise to the off position. Rotate the regulator counter-control
valve counter-clockwise to the off position.
 Combine 2 parts water with 1 part liquid dish soap. Mix well. Apply the
mixed solution to the gas cylinder valve and the regulator control valve.
 Monitor the entire area of the gas cylinder valve and the regulator for
bubbles (A).
 If “growing” bubbles appear, there is a leak. Close LP tank
immediately and retighten all connections.
 NEVER LEAVE GAS CYLINDER VALVE IN THE ON POSITION FOR MORE THAN 12
SECONDS.
 If the soap solution makes the area too slippery for a firm grip, clean the area with a damp cloth to
eliminate the soap. Once corrected, reapply the soap solution and repeat the test.
 When the gas cylinder valve has passed the Gas Leak Test, rotate the regulator control valve
clockwise to the on po
sition and examine the area of the regulator control
valve, down the entire length of the hose and up to the burner for soap
bubbles (B). bubbles (B).
 NEVER LEAVE GAS CYLINDER VALVE IN THE ON POSITION FOR MORE THAN 12
SECONDS.
 NEVER LEAVE GAS CYLINDER VALVE IN THE ON POSITION FOR MORE THAN 12
SECONDS.
 If soap bubbles appear, there is a gas leak in the area. If there is a leak in the area of a
connection, it can be repaired by retightening the fitting. If there is a leak in the hose, the hose
must be replaced before you can continue with operation. DO NOT ATTEMPT TO PATCH THE
HOSE. Once the test is completed without any leaks, you can continue with use of your burner but
you must wait a minimum of five minutes before igniting the burner.
 If soap bubbles appear, there is a gas leak in the area. If there is a leak in the area of a
connection, it can be repaired by retightening the fitting. If there is a leak in the hose, the hose
must be replaced before you can continue with operation. DO NOT ATTEMPT TO PATCH THE
HOSE. Once the test is completed without any leaks, you can continue with use of your burner but
you must wait a minimum of five minutes before igniting the burner.
 Cylinder is not included with appliance.  Cylinder is not included with appliance.
 Never use a gas cylinder without a protective collar or lar
ger than 20 lbs.  Nev
er use a gas cylinder without a protective collar or lar
ger than 20 lbs.
If growing soap bubbles persist throughout any portion of the Gas Leak Test, terminate use immediately.
For assistance with this malfunction, contact your propane dealer or Bruce Foods Corporation at
1-866-752-6497.
If growing s
oap bubbles persist throughout any portion of the Gas Leak Test, terminate use immediately.
For assistance with this malfunction, contact your propane dealer or Bruce Foods Corporation at
1-866-752-6497.